Please Note This forum exists for community support for the Mango product family and the Radix IoT Platform. Although Radix IoT employees participate in this forum from time to time, there is no guarantee of a response to anything posted here, nor can Radix IoT, LLC guarantee the accuracy of any information expressed or conveyed. Specific project questions from customers with active support contracts are asked to send requests to support@radixiot.com.
Re-creating Slave Points
-
I had deleted the slave points from a modbus data source; Will this method work to recreate them: Create a new duplicate data source with a new xid and export the slaves to JSON then change the DS xid to the original and re-importing the points. Would this work to add them back into the data source?
-
I believe your method will work, havn't tested it but I dont see why it will not work...
Try un-check the create slave monitor checkbox then save the data source.
check it again and then save again. Mine recreated it when I did this. -
I tried unchecking the modbus IP Data Source create slave box; saving the data source and rechecking the option and saving again. I also did it after disabling and re-enabling. Sadly No slave points were created from this method..
-
strange I tested it before I posted is your data source modbusIP or modbus serial ? Make sure you have a binary bit data point on that data source with the slave ID that you want to be monitored.
