Please Note This forum exists for community support for the Mango product family and the Radix IoT Platform. Although Radix IoT employees participate in this forum from time to time, there is no guarantee of a response to anything posted here, nor can Radix IoT, LLC guarantee the accuracy of any information expressed or conveyed. Specific project questions from customers with active support contracts are asked to send requests to support@radixiot.com.
Use of the DS2406 switch for input
-
Sadly, no. The samples that Maxim sent i cannot use. When you say it won't work as a sensor, why is that? It should be reading the device's value on each poll.
-
ok - let me have a play applying a voltage to the switch side and see what happens - I am away at the mo so this will take a few days to achieve
If any one else can have a go at this then please feel free to chip in
Francis
-
OK, I will finally get off my butt and send you one of these like I promised.
It works with One Wire Viewer just fine by connecting a switch across it's inputs. I can see the state change in One Wire Viewer.
I could really use this functionality from Mango as well.
http://www.embeddeddatasystems.com/D2--Low-Cost-2-Channel-Digital-IO-1-Wire-Card_p_12.html
Is there any import restrictions to Canada? Special markings?
Mike
-
Document it as a gift of 0 value. This will avoid the astonishing duties and taxes that would otherwise be applied.
-
Oh, but if your device doesn't have a RJ connector, don't bother. I'm not set up for integrating components on to boards or anything.
-
I've got leads soldered to the board now.
On the input side: DQ, Com, +5VDC
On the output side I/O A, com, I/O BThe DS 2406 is mounted on the board with some pullup resistors.
I can do RJ-45 on the input side if you needed it.
-
I got test 1-wire equipment from hobbyboards. If yours is compatible with that, it should be fine.
-
Bump
any news on this - did you manage to test
-
No news.