Thanks, the change of the type of C worked.

Hi Philip,

The temperature points are set to deg C. I have Type set to Analog,
Use unit symbol as suffix is checked and format as 0.0.

Hi all, I have noticed that the displayed values in DGLux for some of the data points I am reading have a question mark ( ?)beside the values even though they display correctly in Mango on the watch lists. Not all values are affected only the temperature values. How do I correct this?

Thanks.

I have been watching the "Mango Dashboard 3.x Video Training Series" and I have been trying to find the rest of the videos in the series, am I missing something as I am unable to locate them.

Hi Guys,

Can the USB port on the mango ES (With the use of a serial converter) be configured to operate simultaneously with the RS485 port for data gathering?

Hello,

I would suggest that a full functioned operating time schedule module be developed to allow quick and seamless deployment on mango. This should allow for holidays and custom overrides.

Ok, noted.

Thanks.

I have not seen the relative humidity(RH) nor the parts per million (ppm) units in the drop down menu. of the points properties.

Hi all. I noticed that my write data and point locator test character encoding is listed as ASCII even though the data source is specified as RTU. The box is grey and I have no access to it, how do I change it to RTU?

How do I examine a number of equivalent data points in several different devices ( ie each at different modbus address) simultaneously.

Can I use a crossover cable to connect my mango ES to my laptop?

I did change the address to 200 for the R6, I also had to change the address for the other device, this I changed to 230. One thing I did notice was that at first, I would get the result for temperature in Hexidecimal but after a while it changed to decimal values.

Hi Phildunlap,

I was able to get another Modbus device display, this device has two data points, temperature and relative humidity, however, I am at a loss as the Barix R6's configuration. Strangely it responds to Modbus poll.
By the way, I have not seen Relative Humidity(RH) in the point properties drop down menu.

When I attempt to write to the device I keep getting:
There was a problem testing the locator. (com.infiniteautomation.mango.io.serial.SerialPortException: Port /dev/rs485-1 in use by Mango Modbus Data Source DS_451699)
Any ideas?

Thanks for your quick response. I have been trying to use Modbus poll from Modbus tools as a master in order to change the R6 address, however, I have been having communication issues with it. I will try the setting listed above and let you know.

Hi all, I am trying to configure a BARIX R6 Modbus relay board. I have created the data source but am now unsure about how to write to the points. I intend to use this module to control loads with the relays.
The following is the register map:

Detailed “register” map – again – please note that the protocol address in Modbus/RTU is the register number -1 !!
Registe r
Function
1 Live I/O (Byte, Relay state in bit 0..5)
2..256 Reserved, not accessible
257 Device type (hex 0xB1)
258 Firmware version
259 Serial number 1st part
260 Serial number 2nd part
261..264 reserved
265..272 One-time writable for installer
273 Default relay setting for startup
274 Serial interface mode
275 Modbus address
276..289 reserved
290..512 Memory for installer/software use
513.... 65536

Any help is greatly appreciated.