Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Please Note This forum exists for community support for the Mango product family and the Radix IoT Platform. Although Radix IoT employees participate in this forum from time to time, there is no guarantee of a response to anything posted here, nor can Radix IoT, LLC guarantee the accuracy of any information expressed or conveyed. Specific project questions from customers with active support contracts are asked to send requests to support@radixiot.com.

Radix IoT Website Mango 3 Documentation Website Mango 4 Documentation Website Mango 5 Documentation Website

R

Topics created by rmc

R

Problem adding a data source - Modbus Serial

Hardware
• • • rmc

22

0
Votes

22
Posts

28.1k
Views

J

Hello jkyner,

Can you be more specific on the following post you made, please?
I've been trying to put my power meter (connected to Mango via Modbus serial) on our LAN using Moxa 5230 without much success.

What data source should I use to configure/connect to the Moxa 5230?
And what "operation mode" should I choose for Moxa 5230 for Mango to connect?

TIA,

joohwan

@jkyner said:

I should have said Mango works fine with a Lantronix Intellibox Modbus Gateway with RTU slaves but also works fine with the Moxa 5130 (a basic Ethernet/RS485 SDA that is not Modbus-aware) for those Modbus slaves that can handle the 6-byte Modbus TCP-RTU header forwarded over RS485.