Hi.

I made a software to get some values from my PLC and it is certainly ok.. but I get response times mostly of 50 ms (although somethimes they vary between 9 to 60 ms). This was my first time working with an industrial protocol and I'm not sure if this results are "the expected ones" or if I'm doing something wrong. I'll leave some images of my results using the CurrentTimeInMillis() method.

Thanks.

Attachment: download link

Hi.

I made a software to get some values from my PLC and it is certainly ok.. but I get response times mostly of 50 ms (although somethimes they vary between 9 to 60 ms). This was my first time working with an industrial protocol and I'm not sure if this results are "the expected ones" or if I'm doing something wrong. I'll leave some images of my results using the CurrentTimeInMillis() method.

Thanks.

Hi mlohbihler
I recently figured out how to write several registers in one request but I can't find how to change data types too, is it even posible?
Thank you.

Hi mlohbihler
I recently figured out how to write several registers in one request but I can't find how to change data types too, is it even posible?
Thank you.

Hi mlohbihler
That's my doubt. How can I write a bunch of registers at once. I was looking at WriteRegistersRequest and WriteRegistersResponse but I don't know.
Thank you.

Hi mlohbihler
That's my doubt. How can I write a bunch of registers at once. I was looking at WriteRegistersRequest and WriteRegistersResponse but I don't know.
Thank you.

Has something to do with RTU over TCP, I think.

Hi, I have a little doubt with setParity parameters.. I wanna know how to set non parity and I don't really see how.

Is it 0 = none, 1 = odd, 2 = even, 3 = mark, 4 = space? thx

Hi, I have a little doubt with setParity parameters.. I wanna know how to set non parity and I don't really see how.

Is it 0 = none, 1 = odd, 2 = even, 3 = mark, 4 = space? thx

Hey thanks :D. And I don't feel bad 'cause that code is really strange to me. I'd never figured it out by myself.